Address storage
With fully charged battery and power keyswitch in the "BACK-UP UNIT", perform this procedure:
1. press the START pushbutton and hold it down until the green and red LEDs light up,
2. wait until the green LED blinks slowly,
3. within 3 seconds, activate in sequence the commands corresponding to PIN 1, PIN 2 and
PIN 3 that compose the PIN code given in the Technical Data Sheet.
If the PIN code is incorrect, the red LED illuminates and the Transmitting Unit switches o.
In this case, the storage procedure shall be repeated.
If the PIN code is correct, the green LED turns steady on and the Transmitting Unit switches
o: this indicates that the address has been stored in the "BACK-UP UNIT". It is now
possible to start the Radio Remote Control and control the Machine with the "BACK-UP
UNIT" Transmitting Unit.
36
LIULK6N03_eng-00
General operating instructions
AUTEC - AIR SERIES
To Next Page
Loading...
Need help?
General
