Signals Possible reason Solutions
The red LED blinks
twice per second during
start up.
At least one of the
commands that were
checked at start-up is
enabled or damaged (see
Technical Data Sheet).
Move the actuators related to the
commands monitored during the start up
to the rest position.
The red LED blinks
three times per second
during start up.
The battery is at. Replace the battery with a charged one.
The red LED is steady
on for two seconds
during start up.
The Transmitting Unit
does not work correctly.
Contact the support service of the
Machine Manufacturer.
The green and red LEDs
are steady on during
start up.
A wrong "Key ID 0-1" or
"ID internal tx memory"
has been inserted in the
Transmitting Unit.
Use the correct "Key ID 0-1" or "ID
internal tx memory".
You are using a "BACK-
UP UNIT" with the "Key
ID 0-1" or "ID internal
tx memory" of the
Transmitting Unit that has
been replaced.
Store the address in the "BACK-UP
UNIT" (see paragraph 8.17).
The green and red LEDs
blink three times per
second during start up.
The "Key ID 0-1" or the
"ID internal tx memory" is
damaged.
Contact the support service of the
Machine Manufacturer.
The green LED is lit
with a steady light and
the red LED blinks two
times per second during
start up.
The START pushbutton is
activated.
Release the START pushbutton.
The green LED repeats
the sequence: 3 blinks
and a pause, and the
red LED is steady on
during start up.
The UNPAIR procedure
provided in the document
"Menu of Transmitting
Unit (MTU)" has been
carried out.
Perform the ALIGNMENT procedure.
AUTEC - AIR SERIES
Maintenance 45
LIULK6N03_eng-00
To Next Page
Loading...
Need help?
General
