13
Chapter 3 Setup
Step 1: Insert the Memory Card
Make sure the SD Memory Card is inserted properly into the MaxiDAS card slot.
1. Insert the SD memory card with the metal contacts facing down and pointing toward
the tool.
2. Remove the card and insert it again if the SD card is not mounting properly.
Note: Do not force the SD card into the card slot. This may damage the card
slot.
Step 2: Connect the Hardware Model& Power Supply
To provide power to this unit, use an external power supply or simply connect this unit to a
vehicle with a communication cable. Press the power button once and wait until the
system boots up. After a brief moment, the MaxiDAS Diagnostic Platform displays and the
tool is now ready to operate. See Chapter 4 on page 10 to assist you to find the DLC on
your vehicle.
Note: The scan tool does not have a battery and can not be charged, make sure
the unit is connected to a power supply before using the scan tool.
To Next Page
Loading...
