18
To perform Automatic Selection
1. Tap the Diagnostics application button from the MaxiDAS Job
Menu. The Vehicle Menu displays.
2. Tap the vehicle brand of the test vehicle.
3. Tap Automatic Selection and the system will proceed to acquire
VIN information automatically. Follow the on-screen instruction to go
into diagnostic screen.
Manual Selection
When the vehicle’s VIN is not automatically retrievable through the vehicle's
ECU, or the specific VIN is unknown, you can choose to select the vehicle
manually.
This mode of vehicle selection is menu driven, repeat the first two steps from
the automatic selection operation and tap Manual Selection. Then you can
follow the on-screen prompts and make a series of choices. Each selection
you make advances you to the next step. A Back button at the bottom right
corner of the screen will bring you back to the previous step. Exact
procedures may vary for different vehicles being serviced.
To Next Page
Loading...
