$11 Pd 1/6
P0115 Generic
Engine Coolant Temperature
Sensor 1 Circuit
z The control module number, sequence of the DTCs, total
number of codes detected and type of codes (Generic or
Manufacturer specific, Stored or Pending codes) will be
observed on the upper right hand corner of the display.
3) If more than one DTC is found, use SCROLL button, as
necessary, until all the codes have been shown up.
z If no codes are detected, a “No codes are stored in the
module!” message displays on the screen.
z If retrieved DTCs contain any manufacturer specific or
enhanced codes, the display indicates “Manufacturer
control”.
$09 4/6
P1324 Other
Manufacturer control
4) Press ENTER/EXIT button to return to previous menu.
4.2 Erasing Codes
CAUTION: Erasing the Diagnostic Trouble Codes may allow the
code reader to delete not only the codes from the vehicle’s on-board
computer, but also “Freeze Frame” data and manufacturer
enhanced data. Further, the I/M Readiness Monitor Status for all
vehicle monitors is reset to Not Ready or Not Complete status. Do not
erase the codes before the system has been checked completely by a
technician.
z This function is performed with key on engine off (KOEO). Do
16
To Next Page
Loading...
