TPMS sensor is successfully activated and
decoded. The tool displays the sensor
information.
If the search period expires and no sensor
activation or decode, it may be wrong
sensor fitting or non-functioning sensor.
The tool displays a message “No sensor
detected.”.
In this case, repeat test to confirm the
TPMS failure.
A TPMS sensor is activated and decoded,
but does not match the protocol for the
Make, Model or Year that the tool was
set-up for. The tool displays a message
“Sensor triggered but cannot be known.”.
In this case, verify the Make, Model or
Year you have selected as well as the
sensor part number that was fitted.
Duplicate ID
(only checked in
All Wheels
mode)
A sensor with a duplicate ID has been
read. The tool displays a message “Sensor
ID Duplicate.”.
In this case, clear data and re-read again.
NOTE: With Ford Banded sensors, the tool should be held 180
degree away from the stem. Please refer to vehicle user’s manual.
If the TPMS sensor requires a magnet, place the magnet over
To Next Page
Loading...
