Autel MaxiTPMS TS408 - Programming by Activation; Copy by Activation Process; Triggering and Programming ID

14
Copy by Activation
This function is used to activate or trigger the original sensor and retrieve the
ID of the sensor, and then write the original sensor ID into the new
MX-Sensor.
Press to select Copy by
Activation. Place the tool near the
sensor to be copied. If the sensor is
still attached to the wheel, hold the
close to the tire sidewall right
above the sensor.
= Confirm
Trigger Succeessful.
Original sensor ID displays on the
screen.
Press Y to program the original
sensor ID into MX-Sensor.
Trigger failed.
Press Y or Trigger to try again.