Autel MaxiTPMS TS408 - Sensor Programming Troubleshooting; Handling Programming Errors; Copy by Manual Input

16
A failure message will display if
the sensor fails to program.
Press any button to continue.
Ensure you are using an
MX-Sensor are that you are
using the correct frequency. Try
to program sensor again.
No sensor detected.
Ensure the unit software is up to
date.
Multiple sensor detected.
Ensure that only one sensor is
close to the tool.
Copy by Manual Input
This function is used to manually input the original sensor ID and program it
to new MX-Sensor.