Cardboard load holder for shipping
In the event your tester needs to be returned to Auto Meter for service,
it must be properly packaged and protected to avoid damage during
shipment. Failure to follow these steps will allow the carbon disks to rattle
freely during shipment and cause breakage. Before packing the tester
for return shipment, turn load knob fully clockwise until it stops, hold in
position and slip a snugly t cardboard holder over the load knob. This
will then rest against the cables and prevent the load knob from turning
back. The load knob holder must be 3-1/2" by 9-3/4" with a 2-3/16" hole
cut out in the center and slightly off-set (copy and use template below).
Please use a thick enough piece of cardboard, preferably corrugated, to
prevent bending and slippage of the load knob.
You can also use a heavy rubber band that wraps around the load knob
while tight then around the leads and back around the load knob again.
For shipping address, see back cover.
To Next Page
Loading...
Need help?
General
