11
A
B+
B
ACC
C
GND
2. The fuse box and constant fuse refers to the power supply components on the car.
A. Connect the yellow wire (B +) to the fuse box (make sure the fuse tap adapter is connected to the yellow wire (B +)).
This wire needs to be connected to the fuse which is a constant power source.How to find it? Using the car test light to check the fuses
if there can get power or not when the car is OFF. If the bulb of the car test light is on, then you find the correct one. To avoid connecting
the fuse which the power will be cut off instantly when the car starts. Please turn the key to Start and check whether the test pencil is on
all the time during starting the car.
B. Connect the red wire (ACC) to the fuse box (ensure that the fuse tap adapter is connected to the red wire (ACC)).
This wire needs to be connected to the fuse which can get power when the car is under ACC position. Switching the key to the ACC
position, then using the car test light to check which fuses can get the power; If the bulb of the car test light is on, then turn off your car,
if the bulb is off, you find the correct one.
C. Black wire (GND).
This wire needs to be connected to the metal of the car (ground part).
To Next Page
Loading...