ENGLISH
26/78
6.2 - SECURING TO SEAT
WARNING: while driving it is necessary to secure “U-GO” in a stable and safe manner in order to avoid
accidental falls and damage to people and things.
If “U-GO” is placed on the passenger’s seat there is a method to secure it by using the vehicle’s safe belt.
WARNING: if placed on the seat it is necessary to secure “U-GO” in a stable and secure manner even if the
vehicle is idle
If “U-GO” is placed in another location, you can use the supplied sling to secure it in the best possible manner.
Securing by means of the vehicle’s seat belt
1
Place “U-GO” on the seat (with the outlet air nozzles set towards the driver).
Solution 1
2
Thread the vehicle’s safe belt through “U-GO”’s
handle near the seat’s backrest: insert it from
below, wrap it around the handle and fasten the
buckle.
Solution 2
2
In case the buckle cannot be threaded through
the handle, employ the following procedure:
fasten the safe belt; now thread the supplied sling
(L) through “U-GO”’s handle, through the safe
belt’s horizontal and oblique straps and close the
ring with the sling’s buckle; tighten as much as
possible in order to have a secure hold.
To Next Page
Loading...