Need help?Do you have a question about the AUTOFLAME Mk8 EGA and is the answer not in the manual?
General| Brand | AUTOFLAME |
|---|---|
| Model | Mk8 EGA |
| Category | Measuring Instruments |
| Language | English |
Describes the advantages and functionalities of the Mk8 EGA system for combustion improvement.
Explains the 3-parameter trim function for optimizing burner combustion and safety.
Describes the Continuous Emissions Monitoring System (CEMS) function of the Mk8 EGA.
Illustrates the pin configuration of data connectors and other wiring aspects.
Details the pin assignments for the mains power and auxiliary connectors.
Provides schematics and interconnection diagrams for EGA, MM, and DTI modules.
Identifies internal and external components, including electrochemical cells like O2, CO, CO2.
Guides through EGA setup, sampling screen, general settings, and cell status.
Covers CEMS setup, including fuel selection, flow source, and unit measurements.
Displays and explains historical data screens for CEMS monitoring.
Details how to perform fuel consumption audits using CEMS data.
Details trim settings, parameters, trim operation, commissioning procedure, and efficiency calculations.
Defines combustion limits (standard, absolute) and provides examples for O2, NO, CO, and temperature.
Provides physical dimensions, electrical, and temperature specifications for the Mk8 EGA.
Details installation, assembly, maintenance, and servicing of the EGA sampling probe.
Describes optional equipment like particulate filters, air inlet filters, and environmental enclosures.
Explains EGA faults, error codes, and general troubleshooting steps.
Discusses trim delay settings and the correct assembly of the dry filter.
Provides guidelines for servicing, shipping, and optimal operation of the EGA.
To Next Page
