Need help?Do you have a question about the AUTOFLAME Mk7 and is the answer not in the manual?
General| Controller Type | Microprocessor-based |
|---|---|
| Linkage-less Burners | Yes |
| Flame Safeguard | Integrated |
| Type | Combustion controller |
| Measurement Parameters | O2, CO, NO, NO2, SO2, CO2, Temperature, Draft |
| O2 Measurement Range | 0-25% |
| CO2 Measurement Range | 0-20% |
| O2 Trim | Yes |
| Variable Speed ID Fan | Yes |
| Communication | Modbus, Ethernet |
| Fuel Types | Gas, Oil |
| CO Measurement Range | 0-2000 ppm |
| SO2 Measurement Range | 0-500 ppm |
| Temperature Measurement Range | 0-1000°C |
| Power Supply | 110-240 VAC |
Provides a detailed procedure for commissioning water level probes and the overall system.
Step-by-step guide for calibrating the TDS probe to ensure accurate measurements.
Details various methods and installation procedures for TDS control systems.
Details configuration options, commissioning, and timer settings for the bottom blowdown module.
Guides on commissioning the bottom blowdown module for standalone operation via PC.
Explains Autoflame's patented steam flow metering technology and its applications.
To Next Page
