Factor
y
Set
ting
V
al
u
e
D
esc
r
i
p
ti
on
600 Blowdown Time:
The time the blowdown valve is opened.
2 - 1200 Seconds
60 Blowdown Interval Time (solenoid valve only):
The time between the top blow down samples for solenoid valve operation only.
2 - 900 Seconds
0 Load Dependent Blowdown Timing (solenoid valve only):
0 Disabled
1 The blowdown time is in prorportion to the firing valve for solenoid valve operation only.
70 MicroSiemens to ppm factor (x100):
The TDS probe measures conducitivity in microSiemens. This factor derives the TDS value in ppm.
20 - 100
10 Steam Pressure Threshold Offset Below Required:
If the M.M. actual value is less than the required value minus this offset, then the top blowdown does not
operate.
0 - 50 PSI. (0.0 -10.0 Bar)
0 Reset Defaults:
Resets all TDS adjusters to the default values and the TDS probe to preset calibraiton. Select YES and
then press RUN.
0 - 1
2500 TDS Target Value:
50 - 9990 ppm
180 Temperature Correction Value:
20 - 300
1000 Calibration Correction:
100 - 9990
25 Settlement Interval Time:
After a blowdown measure, this is a period where the sample can settle before the TDS is measured.
2 - 60 Seconds
5 Measurement Time:
This is how long the sample is measured to get an accurate TDS value.
2 - 10 Seconds
0
ppm or µS
0 ppm
1
µS
0 Upper Limit Offset
0 Disabled
1 - 5000 Once this limits has been exceeded, terminal #79 will be set. On the top blowdown screen, a light blue
dot will flash on the water level button. Press the water level button to mute the alarm. This will continue
to flash until the measured TDS value has fallen below the limit value. Another alarm will not be generated
until the measured TDS value has been continuously below the limit value for 10 minutes.
To Next Page
Loading...