AutomationDirect CLICK C0-12ARE-1-D - Chapter 1

To Next Page

To Previous Page

GettinG Started

Chapter

In This Chapter...

Introduction .............................................................................................................. 1–2

Conventions Used ..................................................................................................... 1–3

Before you begin... ................................................................................................... 1–4

Step 1: Install Programming Software..................................................................... 1–5

Step 2: Launch Programming Software ................................................................... 1–6

Step 3: Create a Project ............................................................................................ 1–8

Step 4: Compile and Save Project .......................................................................... 1–14

Step 5: Apply Power ............................................................................................... 1–15

Step 6: Establish PC to PLC Communications........................................................ 1–16

Step 7: Write Project into PLC ............................................................................... 1–24

Step 8: Place PLC in RUN Mode ............................................................................. 1–25

Step 9: Test Project using Data View Monitor ...................................................... 1–26

Step 10: Y001 Output On? ..................................................................................... 1–27

Additional Training Resources ................................................................................ 1–28

AutomationDirect CLICK C0-12ARE-1-D - Chapter 1 - Getting Started