1
1
1
Chapter
Chapter
Chapter
GettinG Started
In This Chapter...
Introduction ................................................................................................................................... 1-2
Conventions Used........................................................................................................................ 1-3
Before you begin... ....................................................................................................................... 1-4
Step 1: Install Software .............................................................................................................. 1-5
Step 2: Launch Programming Software ................................................................................1-7
Step 3: Set Up User Account .................................................................................................... 1-9
Step 4: Create a Project ...........................................................................................................1-10
Step 5: Compile and Save Project .........................................................................................1-16
Step 6: Apply Power ..................................................................................................................1-17
Step 7: Establish PC to PLC Communications ...................................................................1-18
Step 8: Write Project into PLC ................................................................................................1-30
Step 9: Place PLC in RUN Mode .............................................................................................1-31
Step 10: Test Project using Data View Monitor ................................................................1-32
Step 11: Y001 Output On? .......................................................................................................1-33
Additional Training Resources ...............................................................................................1-34