Need help?Do you have a question about the Autonics TK4H and is the answer not in the manual?
General| Mounting | Panel Mount |
|---|---|
| Display Digits | 4 Digits |
| Input Type | Thermocouple, RTD |
| Control Output | Relay, SSR |
| Display Type | Digital |
| Power Supply | 100-240VAC |
| Control Method | PID, On-Off |
| Operating Temperature | 0 to 50°C |
| Protection Structure | IP65 |
| Communication | RS-485 |
Details the key features of the TK series temperature controller, including high-speed sampling and communication capabilities.
Lists technical specifications such as power supply, input types, accuracy, control outputs, and communication standards.
Explains the physical installation process for TK series controllers, including panel cutout dimensions and mounting procedures.
Provides essential guidelines and precautions for correct wiring of sensors, outputs, and communication lines to prevent damage.
Covers fundamental operations like parameter setting sequence, SV adjustment, and switching between auto/manual control.
Details configuration of input types, ranges, units, bias adjustments, and digital filters for sensor and analog inputs.
Explains control output modes, MV limits, ramp settings, and auto/manual control switching options.
Describes temperature control methods (PID, On/Off), auto-tuning, and settings for proportional, integral, and derivative times.
Details configuration of alarm modes, options, SV settings, hysteresis, delay, and specific alarm types like LBA and SBA.
Covers communication parameters like BPS, parity, stop bits, response time, and unit address settings.
Highlights DAQMaster software features: multi-device support, device scan, project management, data logging, and analysis capabilities.
To Next Page
