Need help?Do you have a question about the Autonics TK4M and is the answer not in the manual?
General| Model | TK4M |
|---|---|
| Accuracy | ±0.3% FS ±1 digit |
| Operating Temperature | 0 to 50 °C |
| Storage Temperature | -20 to 60 °C |
| Panel Cutout | 45 x 45 mm |
| Input Type | Thermocouple, RTD |
| Control Output | Relay |
| Display Type | LED |
| Power Supply | 100-240VAC, 50/60Hz |
| Dimensions (W x H x D) | 48 x 48 x 97.5 mm |
| Control Method | PID, On/Off |
| Setting Resolution | 0.1 °C |
Information regarding the user manual's content and proper usage guidelines.
Explanation of symbols used within the user manual for clarity.
Guidelines and warnings for safe handling and operation of the product.
Recommended environmental conditions for product operation and power usage.
Overview of the key features and capabilities of the TK Series controllers.
Details on the included components and available accessories for the product.
Information on the different models available within the TK Series.
Identification and function of the controller's display elements and control buttons.
Technical specifications and rating details for the TK Series controllers.
Physical dimensions and panel cutout specifications for various TK models.
Instructions and guidelines for installing the temperature controller unit.
Electrical wiring diagrams for different TK Series models.
Important precautions and guidelines for correct electrical wiring.
Procedure for powering on the unit and understanding the initial display.
Guidance on using the input selection switch for sensor configuration.
Fundamental operations and control methods for the temperature controller.
Introduction to the structure and organization of parameter settings.
Configuration options related to sensor input types and ranges.
Parameters for configuring the control output modes and behavior.
Settings and modes for various temperature control methods.
Configuration options for alarm outputs, modes, and hysteresis.
Parameters for setting up communication interfaces and protocols.
Details on extra functionalities like monitoring, run/stop, and error handling.
Description of parameters related to Setting Values (SV) and basic controls.
Parameters for monitoring and controlling Manipulated Variables (MV).
Detailed description of parameters within the first setting group.
Detailed description of parameters within the second setting group.
Detailed description of parameters within the third setting group.
Detailed description of parameters within the fourth setting group.
Detailed description of parameters within the fifth setting group.
Introduction to DAQMaster, a device management program.
Key features and functionalities of the DAQMaster software.
To Next Page
