Autostacker™ Parking Lift 3 P/N 5900248 — Rev. B — May 2021
Table of Contents
Introduction 3 Installation 12
Shipping Information 4 Operation 38
Safety Considerations 4 Maintenance 44
FAQ 6 Troubleshooting 45
Specifications 7 Multi-Autostacker 48
Components 8 Wiring Diagrams 64
Will My Cars Fit? 9 Labels 67
Orientation 10 Parts Diagrams 73
Installation Checklist 11 CE Certificate 83
Introduction
Autostacker is available in two versions:
• A6S. Parking Lift that allows you to make a parking spot that holds just one Vehicle into a parking
spot that holds two Vehicles, lifting vehicles up to 6,000 lbs (2,722 kg).
• A6W. Wide version of the A6S, with an extra 8 inches of width for your Vehicles.
Autostacker is also available in a
Multi-Lift
configuration, where you can control up to 12 Lifts using a
single Master Power Unit.
Unless specifically stated, the setup for each Autostacker in a Multi-Lift configuration follows the same
installation process as a single Autostacker. See Multi-Autostacker towards the end of this manual
for those modified procedures. After you have completed those modified procedures, continue the
remainder of the installation as you would with a single Autostacker; see the Installation Checklist
for an overview of the installation process.
This Manual is mandatory reading for
all Autostacker Lift installers and users
.
⚠ DANGER Be very careful when setting up, operating, maintaining, or repairing this equipment;
failure to do so could result in property damage, product damage, injury, or (in very
rare cases) death. Make sure only authorized personnel operate this equipment. All
repairs must be performed by an authorized technician. Do not make modifications
to the unit; this voids the warranty and increases the chances of injury or property
damage. Make sure to read and follow the instructions on the labels on the unit.
Keep this manual on or near the equipment so that anyone who uses or services it can read it.
Technical support for your product is available directly from your distributor or you can contact
autostacker.com/support or support@autostacker.com. You can also ask for replacement
parts (please have the serial number and model number of your unit available).