16
Problem Cause Solution
Intermittent or irregular brine
draw.
a. Low water pressure.
b. Defective injector
!
a. Increase water pressure.
b. Replace both injector and injector cap.
Contact dealer.
Brine tank overflow. a. Brine valve disc 1 held open.
b. Valve disc 2 and/or 3 not closed
during brine draw, causing brine refill.
c. Air leak in brine line to air check.
d. Salt setting too high.
a. Manually operate valve stem to flush out
foreign matter holding disc open.
b. Manually operate valve stem(s) to flush
out foreign matter holding disc(s) open.
c. Check all connections in brine line for
leaks.
d. See Table 1 for suggested salt settings.
System using more or less
salt than salt setting.
a. Inaccurate setting. a. Correct salt setting. Refer to the
Salt
Setting
section in this manual.
Control backwashes at
excessively low or high rate.
a. Incorrect backwash controller.
b. Foreign matter affecting controller
operation
!
a. Contact dealer.
b. Remove backwash controller. Clean and
replace.
Flowing or dripping water at
drain line after regeneration.
a. Drain valve (5 or 6) held open by
foreign matter.
b. Weak valve stem return spring.
a. Manually operate valve stem to flush out
foreign matter holding disc open. Contact
dealer.
b. Contact dealer.
Table 3 Troubleshooting Procedures
To Next Page
Loading...
