6
Salt Setting
The Salt Setting refers to the total amount of salt, in
pounds, that the control uses during a regeneration of
the resin bed. The amount of salt used in a regeneration
determines the amount of water that the conditioner
softens between regenerations. If this setting is
changed, it may be necessary to change the Capacity
Setting as well. Refer to Table 1 for SALT and
CAPACITY information.
Complete the following steps to change the Salt
Setting:
1. Press the down arrow [↓] button until the green light
next to the SALT legend is on. The display shows a
number with a zero or a five to the right of the
decimal point, no other number can be entered in
this position. The setting range is 0.5 to 99.5 pounds
(0.1 to 25.5 kilograms for metric).
2. Press the
SET
button and the first number starts
flashing. If you want to change this number, press
the up arrow [↑] button to increase the number or
the down arrow [↓] button to decrease the number.
To skip the number without changing, press the left
arrow [←] button.
3. When the number is correct, press the left arrow
[←] button. The first number stops flashing and the
next number starts flashing. You can only change
the flashing number.
4. Continue changing numbers until you reach the
desired setting.
5. Press the
SET
button. The number stops flashing
and the control accepts the new setting. After
approximately 30 seconds, the control starts
alternating the display between TIME OF DAY and
CAPACITY.
Note:
If a beep sounds, the new setting is not
accepted.
If the control does not display this setting, your dealer
has disabled it. Some municipalities require that the
Salt Setting not be adjustable. Contact your dealer for
additional information.
Capacity Setting
The Capacity Setting refers to the kilograins of
hardness that can be removed by the conditioner
between regenerations. Your dealer entered this setting
when the control was installed. Please consult with
your dealer before changing this setting.
*Consult factory for specific settings information.
Table 1 – Suggested Salt Settings (Pounds of Salt for Various Size Conditioners)
Kilograins
of Hardness
Capacity
Setting
0.5 ft
3
0.75 ft
3
1.0 ft
3
1.25 ft
3
1.5 ft
3
1.75 ft
3
2.0 ft
3
*2.5 ft
3
*3.0 ft
3
*3.5 ft
3
124.5- --------
169.05.0--------
20-8.56.0-------
24-14.08.57.0------
30 - - 15.0 11.0 10.0 - - - - -
32 - - 18.5 13.0 11.0 9.0 - - - -
35 - - - 17.0 13.0 11.0 10.0 - - -
40 - - - 23.0 18.0 14.0 13.0 - - -
48 - - - - 28.0 22.0 18.0 14.0 - -
60 - - - - - - 30.0 23.0 18.0 -
72-- -----35.026.023.0
78-- ------30.028.0
81-- ------36.030.0
90-- ------45.038.0
95-- -------42.0
105-- -------56.0
To Next Page
Loading...
