www.autowatch.co.uk P a g e 5 o f 15
Changing your PIN code
Entering learn mode
There are 3 ways to enter Learn Mode:
1. On first installation: - This cannot be used
after the unit has been securely hidden inside
the vehicle and is only used by the installer to
set the initial PIN code.
2. User PIN code change procedure:
a. Switch on your vehicle ignition.
b. Enter your current PIN code (DO NOT
START THE ENGINE!).
c. Press and hold the accelerator pedal to the
floor.
d. Enter your current PIN code again.
e. The Autowatch Ghost will now be in learn
mode, the indication signal will flash every 3
seconds to confirm this. You may now
release the accelerator pedal.
f. Do not switch ignition off before setting the
new PIN code – See instruction on setting a
new PIN once in learn mode.
To Next Page
Loading...
