www.autowatch.co.uk P a g e 9 o f 15
Do not write your PIN code down or share it
with anyone other than those who are allowed
to drive your vehicle.
Before you start the learn process, plan your PIN
code so that there is no hesitation whilst trying to
learn it into the Autowatch Ghost. Now that you
have your new PIN code in mind let’s learn it in:
1. Your vehicles ignition will be switched on
following one of the 3 ways to enter learn
mode as described above. This is confirmed
by the indication signal flashing every 3
seconds)
2. Enter your new PIN code.
3. Wait for 3 flashes of the indication signal.
4. Enter the same new PIN code again.
5. Wait 2 seconds.
6. IF the new PIN code has been correctly
entered and accepted the indication signal will
flash twice.
7. IF the new PIN code was not correctly
entered the indication signal will flash 4 times.
The unit will again be in learn mode and you
may attempt to learn the new PIN again.
To Next Page
Loading...
