AVA WEIGH 334PCSP60 User Manual (English)

Questions and Answers:

F
frankbeltranSep 12, 2025
What to do if my AVA WEIGH Scales has no display or display but no characters?
- S
  Sonia ReedSep 12, 2025
  If your AVA WEIGH Scales has no display or shows a display without characters, it may be due to the display pole not being installed properly, resulting in poor contact with the control board; re-install the display pole with a lock fixed bolt. Another cause could be water in the display pole base, causing a shortage and corrosion on the circuit board; replace the circuit board or display pole. The display itself may also be damaged, requiring a display pole replacement.
D
Donna JacksonSep 12, 2025
Why does my AVA WEIGH Scales boot up without any sound, display “Update”?
- M
  Michael BarrettSep 12, 2025
  If your AVA WEIGH Scales boots up without sound and displays “Update”, it could be due to a program download error or misoperation during the downloading of the program (such as halfway power outage). Reload following the correct procedures. Reset the IP (default is 192.168.1.87) when updating by Ethernet. If updating by serial port, input any number as the scale's ID (the maximum baud rate is 115200).
L
Linda BushSep 14, 2025
What to do if my AVA WEIGH Scales makes a "ka ka" sound when printing?
- C
  Christopher MoonSep 14, 2025
  If your AVA WEIGH Scales is making a "ka ka" sound when printing, it could be due to incorrectly installed paper causing a paper jam; reinstall the paper correctly. The paper receiving shaft may also be jammed; reinstall the paper receiving shaft. Alternatively, there may be debris between the small and big gear; check the gear and remove any debris.