Why does my AVA WEIGH Scales show Err01?
Err01 on your AVA WEIGH Scales indicates that the weight exceeds the maximum capacity or the load cell output signal is too large. Remove the object from the scale. If the issue persists, consider changing the load cell and recalibrating the scale.
What to do if my AVA WEIGH 334PCS40 Scales shows Lo.bAt?
If your AVA WEIGH Scales displays 'Lo.bAt', it means the voltage is lower than 5.7V. The solution is to charge the battery.
Why are my AVA WEIGH 334PCS40 inaccurate?
Inaccurate weighing on your AVA WEIGH Scales can occur if different areas of the platform give different weight readings, the platform or feet are not level, the load cell is broken, or there are objects between the load cell and the scale. Ensure the platform is level and all four feet are on a solid, level surface. Clear any obstructions. If the problem continues, replace the load cell.
How to fix Err20 on AVA WEIGH Scales?
Err20 on AVA WEIGH Scales suggests a load cell issue, such as no signal, too small or large output, a broken signal wire, a broken load cell, or changes in the load cell zero point. Try to recalibrate the scale. If that doesn't work, replace the PCB or the load cell.
How to fix Err05 on AVA WEIGH 334PCS40?
Err05 on your AVA WEIGH Scales indicates that one foot is not standing on a solid base, the platter was removed before power-on, or the zero point is below the setting range. Place the platter back on the scale. Then, calibrate the scale again. If the issue continues, replace the load cell.
What to do if my AVA WEIGH Scales calibration can't be finished?
If calibration cannot be finished on your AVA WEIGH Scales, it could be due to the inner code at zero point being too small or too large, the scale being unstable, objects between the load cell and the scale, or a broken load cell. Recalibrate the scale. If that doesn't work, replace the PCB. Also, clear any objects. As a last resort, replace the load cell.
How to fix Err04 on AVA WEIGH 334PCS40 Scales?
Err04 on AVA WEIGH Scales means the object on the platform is more than 1.5%FS when pressing the ZERO key, indicating a setting range issue. Remove the objects from the platform. Calibrate again, or replace the load cell if the problem persists.
Why won't my AVA WEIGH 334PCS40 Scales display anything?
A lack of display on your AVA WEIGH Scales could be due to several reasons: * Damage to electrical components: Replace with a new PCB. * Key button malfunction: Replace with a new key button. * Crystal-oscillator malfunction or MCU incorrectly inserted: Replace the crystal-oscillator or correctly insert the MCU.
How to fix Err03 on AVA WEIGH 334PCS40?
Err03 on your AVA WEIGH Scales indicates that the platter was removed while the scale was on, or the weight signal is too small. Place the platter back on the scale.
How to fix Err30 on AVA WEIGH 334PCS40?
Err30 on AVA WEIGH Scales suggests the ADC is over the maximum range or the load cell signal is too large. Replace the load cell or replace the PCB.
Important safety guidelines for scale operation and environment.
Step-by-step guide for calibrating the scale.
What to do if calibration errors occur.
Solutions for power-on issues and specific error codes.
Troubleshooting common functional malfunctions.
To Next Page
General
