1. Take the scale out of the box and place it on a firm, level surface. Avoid locations with rapid
temperature changes, excessive dust, moisture, air currents, vibrations, electromagnetic fields,
heat, or direct sunlight.
2. Adjust the leveling feet until the bubble is centered in the circle of the
level indicator (located on the front panel).
NOTE: Ensure that the scale is level each time it’s location is changed.
3. Before using the scale for the first time, the internal rechargeable battery should be fully
charged for up to 12 hours.
4. Connect the supplied AC adapter to the power input receptacle underneath the scale. Plug
the AC adapter into a properly grounded power outlet and the battery will begin charging.
5. If the scale will be stored or transported in the future, save the packaging material to ensure
the best possible protection for the scale.
1. Install the weighing platforms onto the base, with the pan properly aligned.
1. Install the weighing platforms onto the base,
with the pan properly aligned.
2. Install the tower display.
• Pass the socket on the bottom of the scale base through
the pole bracket, and plug it into the connector.
• Connect the column to the base and tighten together
with the hexagon socket head cap screws.
• Place the connector in the bracket, put on the cover,
and fix it with tapping screws.
• Scale
• Weighing Platforms
• 12Vdc/500mA Adapter
• Manual
• Tower Assembly
(334PCS40T Only)
UNPACKING & SETUP
3.
PACKING LIST
ASSEMBLY
334PCS40
334PCS40T
No. Item
1 Scale Base
2 Hexagon Socket Head Cap Screws (3 pcs)
3 Cover
4 Tapping Screws (2 pcs)
5 Column
6 Connector
7 Socket
To Next Page
Loading...
