18
7. Locate the second Small PE Tubing. Connect
one end of the Small PE Tubing to the right
side inlet of the right Filter Adapter. Connect
the other end of that Small PE Tubing to the
water inlet (#20).
8. Locate the valve on the Vale and Tube
Assembly. Turn this valve to the on position
(parallel to the PE Tubing) to allow water to
flow through.
6. Remove the plug from the water inlet (#20)
located on the back of the unit. To do this
press on the push connect ring in towards the
cooler and remove the plug at the same time.
Finishing the Water Cooler Installation
Getting Started
To Next Page
Loading...
