Name: Avantco 178CBE36HC
Brand: Avantco
Rating: 5 (1 reviews)

Other manuals for Avantco 178CBE36HC

User Manual12 pages

Questions and Answers:

J
Joseph AshleyAug 2, 2025
Why is my Avantco 178CBE36HC cabinet temperature too warm?
- W
  Wesley AyalaAug 2, 2025
  Several factors can cause this. The thermostat might be set too warm, so try setting it to a lower temperature. Blocked airflow can also be the culprit; rearrange the product to allow proper airflow, ensuring at least four inches of clearance from the evaporator. Additionally, putting too much warm product in the cabinet can raise the temperature; allow adequate time for the product to cool down. A blown fuse or tripped circuit breaker could also be the cause; replace the fuse or reset the circuit breaker. A dirty condenser coil can also cause this problem, so clean the condenser coil. Finally, an iced-over evaporator coil might be the reason; ensure drawers are closed when not in use and avoid opening drawers for long periods of time.
M
Mrs. Janet Sosa MDAug 6, 2025
Why does my Avantco Commercial Food Equipment condensing unit run for long periods of time?
- F
  Felicia HintonAug 6, 2025
  Several factors can cause this issue. An excessive amount of warm product placed in the cabinet might be the cause; allow adequate time for the product to cool down. Prolonged drawer opening or a drawer left ajar can also lead to this; ensure drawers are closed when not in use and avoid opening them for long periods. Another reason might be drawer gaskets not sealing properly; ensure gaskets are snapped in completely, remove them and wash them with soap and water, and replace them if necessary. A dirty condenser coil can also cause this; clean the condenser coil. Finally, an iced-over evaporator coil could be the problem; unplug the unit and allow the coil to defrost, make sure the thermostat is not set too cold, and ensure that the door gaskets are sealing properly.
C
Cameron RothAug 10, 2025
What to do if the compressor is not running on my Avantco 178CBE36HC Commercial Food Equipment?
- M
  Meghan JordanAug 10, 2025
  If the compressor isn't running, start by checking the fuse or circuit breaker; replace the fuse or reset the circuit breaker if needed. Ensure the power cord is properly plugged in. Also, check the thermostat setting; if it's set too high, lower the temperature. Finally, if the cabinet is in defrost cycle, wait for it to finish.