Name: Avantco 178CBE72HC
Brand: Avantco
Rating: 5 (1 reviews)

Other manuals for Avantco 178CBE72HC

User Manual12 pages

Questions and Answers:

B
bsextonJul 25, 2025
Why is my Avantco 178CBE72HC Commercial Food Equipment cabinet temperature too warm?
- A
  Ashley WellsJul 25, 2025
  Several factors can cause this. The thermostat might be set too warm, so try setting it to a lower temperature. Blocked airflow can also be the culprit; rearrange the product to allow proper airflow, ensuring at least four inches of clearance from the evaporator. Additionally, putting too much warm product in the cabinet can raise the temperature; allow adequate time for the product to cool down. A blown fuse or tripped circuit breaker could also be the cause; replace the fuse or reset the circuit breaker. A dirty condenser coil can also cause this problem, so clean the condenser coil. Finally, an iced-over evaporator coil might be the reason; ensure drawers are closed when not in use and avoid opening drawers for long periods of time.
K
kristin79Jul 30, 2025
Why does my Avantco 178CBE72HC Commercial Food Equipment condensing unit run for long periods of time?
- V
  Victoria LewisJul 30, 2025
  Several factors can cause this issue. An excessive amount of warm product placed in the cabinet might be the cause; allow adequate time for the product to cool down. Prolonged drawer opening or a drawer left ajar can also lead to this; ensure drawers are closed when not in use and avoid opening them for long periods. Another reason might be drawer gaskets not sealing properly; ensure gaskets are snapped in completely, remove them and wash them with soap and water, and replace them if necessary. A dirty condenser coil can also cause this; clean the condenser coil. Finally, an iced-over evaporator coil could be the problem; unplug the unit and allow the coil to defrost, make sure the thermostat is not set too cold, and ensure that the door gaskets are sealing properly.
A
Alexis ClarkeAug 3, 2025
What to do if the compressor is not running on my Avantco Commercial Food Equipment?
- W
  wesley00Aug 3, 2025
  If the compressor isn't running, start by checking the fuse or circuit breaker; replace the fuse or reset the circuit breaker if needed. Ensure the power cord is properly plugged in. Also, check the thermostat setting; if it's set too high, lower the temperature. Finally, if the cabinet is in defrost cycle, wait for it to finish.
P
Paul CortezAug 7, 2025
What to do if my Avantco 178CBE72HC unit will not turn on?
- K
  Karen FitzgeraldAug 7, 2025
  If your Avantco commercial food equipment won't turn on, here are a few things to check: * Make sure the unit is properly plugged into a functioning and dedicated outlet. * Inspect the power switch and controller.
E
emily90Aug 11, 2025
Why is my Avantco 178CBE72HC Commercial Food Equipment unit not getting to the set temperature?
- M
  Manuel ColemanAug 11, 2025
  If your Avantco commercial food equipment isn't reaching the set temperature, consider the following: 1. Ensure the drawers are completely closed. 2. Inspect the drawer gasket for any damage like rips or cuts. 3. Confirm the ambient air temperature is not exceeding 90°F. 4. Check and clean the condenser coil. 5. Verify the set temperature and controller parameters are correct. 6. Look for ice or frost buildup on the evaporator coil. 7. Check the operation of the evaporator and condenser fans, as well as the compressor. 8. Inspect the cabinet temperature sensor and controller.

Avantco 178CBE72HC Specifications

General

Model	178CBE72HC
Width	72 1/4 Inches
Horsepower	1/4 HP
Voltage	115 V
Phase	1
Installation Type	Freestanding
Temperature Range	33 - 40 Degrees F
Hertz	60 Hz
Door Style	Solid
Refrigerant Type	R290
Temperature	33 - 40°F
Features	Adjustable Shelves

Related product manuals

Avantco 178CBE72HC Service Manual

Table of Contents

Other manuals for Avantco 178CBE72HC

Questions and Answers:

Avantco 178CBE72HC Specifications

Related product manuals