Why is my Avantco Commercial Food Equipment too hot?
If your Avantco Commercial Food Equipment is getting too hot, try changing the temperature to a lower setting. If that doesn't work, it could be connected to an incorrect power supply or have a defective internal thermostat. In either of these cases, contact an authorized electrician.
How to fix Avantco Commercial Food Equipment not hot enough?
If your Avantco Commercial Food Equipment is not hot enough, first allow the unit 30 minutes to preheat, you can accelerate this by closing the drawer vents. Also, make sure all drawers are completely closed and that the temperature control is set to a higher setting. If the problem persists, the internal thermostat may be defective, and you should contact an authorized electrician.
What to do if product is too dry in Avantco Commercial Food Equipment?
If your product is too dry when using Avantco Commercial Food Equipment, make sure the drawer vent is closed. Also, check if the water pan is empty or not installed; if so, install or fill the water pan and control the moisture level using the drawer vents.
Why is product too moist in Avantco Commercial Food Equipment?
If your product is too moist when using Avantco Commercial Food Equipment, move the drawer vent to the open position. If a water pan is installed but not needed, remove it from the drawer.
General| Model | 178SSPPT1 |
|---|---|
| Number of Shelves | 6 |
| Exterior Material | Stainless Steel |
| Interior Material | Aluminum |
| Number of Doors | 1 |
| Voltage | 115V |
| Phase | 1 |
| NSF Listed | Yes |
| ETL Listed | Yes |
| Door Style | Solid |
| Refrigerant | R290 |
| Horsepower | 1/3 HP |
| Shelf Material | Epoxy Coated Steel |
To Next Page