Avantco FF400 - Installation: Legs, Casters, and Restraints

User Manual
6 www.AvantcoEquipment.com
Step 2: Install the Legs (or optional casters) and Restraints.
A set of legs or casters is packed with the fryer. Mounting fasteners are pre-mounted on the baseplates.
1. Raise fryer suciently to allow legs or casters to be screwed into the baseplate. For safety, “shore up” and
support the fryer with an adequate blocking arrangement strong enough to support the load.
2. Screw the four legs or casters to the plate on the bottom of the fryer. When casters have been ordered, the
casters having a locking-brake should be attached under the front of the fryer.
3. Lower the fryer gently. Never drop or allow the fryer to fall.
4. Use a level to make sure that the fryer is level. Each caster, or the tubular-end of each leg, can be screwed in
or out to lower or raise each corner of the fryer.
5. Attach restraints as required by local codes.
NOTICE
Unit must be level to ensure maximum performance. Improper leveling may void warranty.
NOTICE
When this appliance is installed with casters, it must be installed with the casters supplied, a connector complying
with either ANSI Z21.69 CSA 6.16 and a quick-disconnect device complying with ANSI Z21.41 CSA 6.9. It must also
be installed with restraining means to guard against transmission of strain to the connector, as specied in the
appliance manufacturer instructions.
WARNING
If disconnection of the restraint is necessary to move the appliance for cleaning, etc., reconnect it when the
appliance is moved to its original installed position.
WARNING
When this appliance is installed with casters, it must be installed with the casters supplied, a connector complying
with either ANSI Z21.69 or CAN/CGA-6.16 and a quick disconnect device complying with either ANSI Z21.41 or
CAN1-6.9. It must also be installed with restraining means to guard against transmission of strain to the connector,
as specied in the appliance manufacturer's instructions.
WARNING
All fryers must be restrained to prevent tipping in order to avoid the splashing of hot liquid. The means of restraint
may be the manner of installation.