EasyManua.ls Logo

Avantco SCL Series - User Manual

Avantco SCL Series
41 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
COMMERCIAL
REFRIGERATOR & FREEZER
SERVICE MANUAL
(SCL/SCLM)
MODEL: SCL1
SCL2
SCL2-36
SCL2-60
SCL3
SCLM1
SCLM2
SCLM2-36
SCLM2-60
SCLM3

Questions and Answers

  • J
    Jeffrey LopezAug 19, 2025
    What to do if my Avantco SCL Refrigerator is too warm?
    • J
      Jill ReedSep 12, 2025
      If the interior of your Avantco Refrigerator is too warm, the temperature control may be set too warm. Try setting the controller to a colder setting and allow several hours for the temperature to stabilize. Also, warm air entering the appliance from opening the door too frequently or keeping it open too long can cause the temperature to rise, so open the door less often and ensure it is completely closed. If you've recently stored a large amount of warm or hot food, wait until the appliance has had a chance to reach its selected temperature. Finally, if the appliance has recently been disconnected, remember that it requires hours to cool down completely.
  • M
    Mary HowardAug 21, 2025
    What to do if my Avantco SCL does not run?
    • M
      Mark ShawAug 21, 2025
      If your Avantco Refrigerator isn't running, first, make sure it's properly plugged into the outlet. If it is, check to see if the outlet has a ground fault and try using another circuit, having it checked by a certified technician if you're unsure. Also, verify that the temperature control isn't in the "OFF" position. Check the house fuse and replace it with a 15 amp time delay fuse or reset the circuit breaker if necessary. Finally, check for a power outage by checking house lights and calling your local Electric Company if needed.
  • D
    Dawn KimAug 26, 2025
    Why is my Avantco SCL Refrigerator too cold?
    • G
      glenn61Aug 26, 2025
      If the interior temperature of your Avantco Refrigerator is too cold, the temperature control may be set too low. Set the controller to a warmer setting and allow several hours for the temperature to stabilize.
  • L
    Lauren WaltersAug 27, 2025
    Why is the surface of my Avantco Refrigerator warm?
    • F
      fernandezrandyAug 27, 2025
      If the external surface temperature of your Avantco Refrigerator is warm, it's normal for the external appliance walls to be as much as 30ºF warmer than room temperature while the compressor works to transfer heat from inside the appliance cabinet.
  • S
    sharpadrianaAug 29, 2025
    How to fix a vibrating Avantco SCL?
    • P
      Pamela StevensAug 29, 2025
      If your Avantco Refrigerator is making a vibrating or rattling noise, it might not be level. Try leveling the appliance by putting wood or metal shims under the part of the appliance that needs it. Also, make sure the floor can adequately support the appliance, and if the floor is uneven, use shims to level the appliance. Ensure the appliance is not touching the wall; if it is, re-level it or move it slightly.
  • J
    Jorge CardenasSep 1, 2025
    Why is there moisture inside my Avantco SCL Refrigerator?
    • V
      Victor FletcherSep 1, 2025
      If moisture forms on the inside walls of your Avantco Refrigerator, it could be due to hot and humid weather, which increases the internal rate of frost build-up – this is normal. Ensure that the door is closed completely, and avoid keeping the door open too long or opening it too frequently.
  • Y
    ywrightSep 3, 2025
    What to do if the Avantco SCL door won't close?
    • A
      Amanda SmithSep 3, 2025
      If the door of your Avantco Refrigerator won't close, the appliance might not be level. Level the appliance by putting wood or metal shims under the part of the appliance that needs it. Additionally, ensure the floor can adequately support the appliance, and if the floor is uneven or weak, use shims to level it.
  • C
    Charles PayneSep 5, 2025
    How to eliminate odors in my Avantco SCL?
    • N
      Nancy MillerSep 5, 2025
      If there are odors in your Avantco Refrigerator, the interior may need to be cleaned with a sponge, warm water, and baking soda. Also, ensure that any foods with strong odors are tightly covered.
  • A
    Aimee ZamoraSep 7, 2025
    Why is the light bulb not working in my Avantco SCL Refrigerator?
    • L
      Luis VelasquezSep 7, 2025
      If the light bulb in your Avantco Refrigerator is not on, the fluorescent lamp or light bulb may be burned out. Turn off the power and replace it with a new lamp. Also, check the plug and house lights to ensure electric current is reaching the appliance.
  • D
    Daniel AndersonSep 9, 2025
    Why is my Avantco SCL so loud?
    • R
      robert17Sep 9, 2025
      If your Avantco Refrigerator has louder sound levels when it's on, it's normal because modern appliances have increased storage capacity and more stable temperatures, requiring heavy-duty compressors. When the surrounding noise level is low, you might hear the compressor running while it cools the interior.

Summary

Exploded View and Parts List

SCL1 & SCLM1 Exploded View

Detailed diagrams showing the assembly and placement of parts for SCL1 and SCLM1 models.

Controller Instruction

Refrigerator Controller Operation

Guide to operating and configuring the digital refrigerator controller, including display and button functions.

Replacement of Main Parts

Door Replacement Procedure

Step-by-step instructions for removing and installing the appliance door and its hinges.

Temperature Display Replacement

Procedure for replacing the Fahrenheit temperature display unit on specific models.

Compressor & Condenser Unit Replacement

Instructions for safely removing and replacing the compressor and condenser unit.

Lids and Evaporator Unit Replacement

Steps for removing and replacing the appliance lids and the evaporator fan motor assembly.

Troubleshooting

Avantco SCL Series Specifications

General IconGeneral
BrandAvantco
ModelSCL Series
CategoryRefrigerator
LanguageEnglish

Related product manuals