Avantco SCL2 - Temperature Controls; Adjusting the Temperature

- 3 -
User Manual
Temperature Controls
• Refrigerant LED - Compressor is on
• Fan LED - Fan is on
• Defrost LED - Defrost cycle is running
Functions
Adjusting the Temperature
Refrigerators are programmed to operate between 33 and 40 degrees Fahrenheit.
Freezers are programmed to operate between -10 and +10 degrees Fahrenheit.
To set the temperature you would like your unit to run at, follow these instructions:
• Hold “SET” for 1 sec. The display will flash the temperature that the refrigerator is currently set to
run at.
• Use the arrow buttons to adjust the temperature you want it to run at.
• Press “SET” again to save your settings
If the unit consistently runs 5 + degrees higher than your set temperature, service may be needed.
Note: All other control functions should be performed by a service technician.
CAUTION
Setting the temperature control to the coldest setting may cause the evaporator coil to freeze and ice
up. This will eventually result in a warmer cabinet temperature.
NOTE
Temperature controls on the pizza prep refrigerators are located on the front of the units.
Temperature controls on the sandwich prep tables and undercounter refrigerators and freezers are
located on the back of the units.
Prg
mute
Set
aux
def
Freezer Control
set
mute
Refrigerator Control