Caution:
When mounting this device in a rack, do not stack units directly on top of one another in the
rack. Each unit must be secured to the rack with appropriate mounting brackets. Mounting
brackets are not designed to support multiple units.
Voltage:
Use only power cords that have a grounding path. Without a proper ground, a person who
touches the switch is in danger of receiving an electrical shock. Lack of a grounding path to
the switch can result in excessive emissions.
Warning:
Disconnecting the power cord is the only way to turn of
f power to this device. Always connect
the power cord in a location that can be reached quickly and safely in case of an
emergency.
Warning:
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look
into an optical fiber or connector port. Always assume that fiber optic cables are connected
to a light source.
Installation preparation
Related topics:
Before you begin on page 4
Installing the ERS 3510GT or ERS 3510GT-PWR+ switch on a table or shelf on page
4
Installing two ERS 3510GT or ERS 3510GT-PWR+ switches in an equipment rack on
page 6
Installing a single ERS 3510GT or ERS 3510GT-PWR+ switch in an equipment rack on
page 10
Installing the ERS 3524GT, ERS 3524GT-PWR+, ERS 3526T, or ERS 3526T-PWR+ switch
in an equipment rack on page 14
Connecting AC power on page
15
Installation preparation
February 2013 3
To Next Page
Loading...
