Avaya 3500 series - Installing a Single ERS 3510 GT or ERS 3510 GT-PWR+ Switch in an Equipment Rack

6. Slide the switches into the rack. Insert and tighten the rack mount screws.
7.
Verify that the switch is securely fastened to the rack.
Installing a single ERS 3510GT or ERS 3510GT-PWR+ switch in an
equipment rack
Before you begin
Hardware included with ERS 3510GT and ERS 3510GT-PWR+ model switches:
• Avaya Ethernet Routing Switch 3500 Series
• Rubber footpads
• AC power cord (Note: a power cord is not included for the A variant of the switch)
• Base Software License Kit
• Screws (2) and wall anchors (2) for wall mounting
Tool requirements:
• a Phillips screwdriver to attach brackets to the switch and the switch to the rack
Bracket requirements:
• one 3510–Single Rack Mount Kit — this accessory kit is used to mount a single ERS 3510GT
or ERS 3510GT-PWR+ switch in a standard 19 inch rack. The kit contains the necessary
Installation preparation
10 February 2013