3. Attach the standard rack mount bracket ears to the outer end of each switch as
shown below.
4. Once the switches are joined together, fold the hinged bracket inward.
5. Perform one of the following
• T
o connect two ERS 3510GT or two 3510GT-PWR+ switches together use
the rear bracket as shown below, with four M4 pan head screws to secure the
switches at the rear. Once the rear bracket has been installed, the switches
can be installed in the rack.
• T
o connect one ERS 3510GT switch and one ERS 3510GT-PWR+ switch
together use the offset rear bracket with four M4 pan head screws to join the
switches at the rear. Once the rear bracket has been installed, the switches
can be installed in the rack.
Note:
If you are mounting a mix of ERS 3510GT and ERS 3510GT
-PWR+ units side
by side, ensure that the ERS 3510GT unit is mounted on the LEFT side (when
viewed from the front) for adequate airflow.
Installation preparation
February 2013 9
To Next Page
Loading...
