ffffffffffffffffffffffffffffffffffffff
Changing from AT Local Mode to CMD Local Mode
To exit AT mode and return to the CMD local mode, type:
at&&t
or
at&&a
If there is no data call active, the ADM responds:
Call Status: Idle
Type H for help
CMD:
If there is a data call active, the system responds:
Call Status: Data Call Active
Type H for help
CMD:
AT Commands
The following table shows the AT commands supported by the ADM for basic data applications.
Refer to the ISDN Application Programming Interface Programmer’s Manual for a complete
description of all AT commands, particularly the enhanced AT command set for monitoring and
control of all ISDN terminal voice and data functions.
Note: If your PC communications package requires you to set an option that cannot be
accessed with the set of AT commands listed in Table 3-2, you will have to use a CMD
local mode command to set the option.
Using the CMD and AT Commands 3-9
To Next Page
Loading...
