Avaya ERS 3500 Series - Installing the ERS 3510 GT or ERS 3510 GT-PWR+ Switch on a Table or Shelf

• at least 2 inches (5.1 cm) (or one vertical rack width) on all sides of the switch unit for
ventilation
• adequate space at the front and rear of the switch for access to cables
If you are installing a single Ethernet Routing Switch 3524GT, 3524GT-PWR+, 3526T, or
3526T-PWR+ on a table or shelf, ensure the surface can support at least 7 to 10 pounds (3 to
4.5 kilograms) .
Installing the ERS 3510GT or ERS 3510GT-PWR+ switch on a table
or shelf
About this task
You can install a single ERS 3510GT or ERS 3510GT-PWR+ switch on any flat surface that
can safely support the weight of the switch and attached cables. An ERS 3510GT switch
weighs 3.85 lb (1.75 kg). An ERS 3510GT-PWR+ switch weighs 5.9 lb (2.70 kg). Cable weight
varies for each installation.
The following procedure provides instructions for installing the switch on a table or shelf.
Important:
Allow at least 2 inches (5.1 cm) on each side of the switch for proper ventilation and at least
5 inches (12.7 cm) at the back of the switch for power cord clearance.
Procedure
1. Attach the rubber feet at the marked locations.
English
24 Regulatory Information 5.0 February 2012
Comments? infodev@avaya.com