Installing two ERS 3510GT or ERS 3510GT-PWR+ switches in an
equipment rack
Before you begin
Tool requirements
• a Phillips screwdriver to attach brackets to the switch and the switch to the rack.
Bracket requirements
• one 19 inch Side-by-Side Rack Mount Kit — this accessory kit is used to connect two ERS
3510GT switches together side-by-side.. The kit includes all necessary brackets and
fasteners and must be ordered separately (Order Code AL3511002–E6).
The contents of the Side-by-Side Rack Mount Kit are as described below:
- 1. Rack mount brackets — Quantity: 2
- 2. M4 flat head screws — Quantity: 14
- 3. Hinged mating bracket — Quantity: 1
- 4. Rear bracket for mating identical 3510 switches — Quantity: 1
- 5. Rear bracket for mating 3510GT and 3510GT-PWR+ switches — Quantity: 1
- #10–32 rack mounting screws (not shown) — Quantity: 4
- #12–24 rack mounting screws (not shown) — Quantity: 4
- M6 rack mounting screws (not shown) — Quantity: 4
English
26 Regulatory Information 5.0 February 2012
Comments? infodev@avaya.com
To Next Page
Loading...
