Avaya ERS 5510 - Page 57

Filt
Filters and QOS Configuration for Ethernet Routing Switch 5500
Technical Configuration Guide
57
January 2013
avaya.com
6 Untrusted
8 Untrusted
9 Untrusted
10 Untrusted
12.3.2.3 Verify IP Source Guard
Step 1 – To view the IP Source Guard binding, enter the following command, assuming we have port
member on ports 6 and 9
ERS5500-24T# show ip source binding
Result:
Port Address
---- ---------------
6 10.62.32.10
9 10.13.196.10

An IP source Guard or ARP Inspection event will be logged (local and remote if enabled)
indicated by the message, i.e. from port 6: “ARP packet with invalid IP/MAC binding on un-
trusted port 1/6”.
12.3.2.4 Verify ACL Configuration
Step 1 – To view the IP ACL configuration, enter the following command:
ERS5500-24T# show qos ip-acl
Result:
Id: 1
Name: one
Block:
Address Type: IPv4
Destination Addr/Mask: 172.30.30.50/32
Source Addr/Mask: Ignore
DSCP: Ignore
IPv4 Protocol / IPv6 Next Header: ICMP
Destination L4 Port Min: Ignore
Destination L4 Port Max: Ignore
Source L4 Port Min: Ignore
Source L4 Port Max: Ignore
IPv6 Flow Id: Ignore
Action Drop: No
Action Update DSCP: Ignore
Action Update 802.1p Priority: Ignore
Action Set Drop Precedence: Low Drop
Type: Access List
Storage Type: NonVolatile
Id: 2
Name: one
Block:
Address Type: IPv4
Destination Addr/Mask: 172.30.30.50/32
Source Addr/Mask: Ignore
DSCP: Ignore
IPv4 Protocol / IPv6 Next Header: UDP
Destination L4 Port Min: 67
Destination L4 Port Max: 67
Source L4 Port Min: Ignore