Avaya ERS 5510 - Page 70

Filt
Filters and QOS Configuration for Ethernet Routing Switch 5500
Technical Configuration Guide
70
January 2013
avaya.com
ERS5500 Step 1 – Create a Classifier Block
5500(config)# qos classifier-block 1 block-number 1 name b1 set-id 1 in-profile-action
4
5500(config)# qos classifier-block 2 block-number 1 name b1 set-id 2 in-profile-action
5
5500(config)# qos classifier-block 3 block-number 1 name b1 set-id 3 in-profile-action
6
12.7.3.3 Create Policy
ERS5500 Step 1 – create a new policy with classifier block 1 with a non-match-action of Bronze
service
5500(config)# qos policy 1 name pbit if-group unrestricted clfr-type block clfr-id 1
non-match-action 9 precedence 11
12.7.4 Verify Operations
12.7.4.1 View the Queue Assignments
The following commands are useful to display the queue mapping pertaining to the ACL configuration
from above.
Step 1 – Use the following command to view the internal mapping of p-bit to queue for queue set 8; note,
results are only shown for queue set 8
ERS5500-24T# show qos queue-set-assignment
Result:
Queue Set 8
802.1p Priority Queue
_______________ _____
0 8
1 7
2 6
3 5
4 4
5 3
6 1
7 2
Step 2 – Use the following command to display queue set 8; ; note, results are only shown for queue set
8
ERS5500-24T# show qos queue-set
Result:
Set Queue General Bandwidth Absolute Bandwidth Service Size
ID ID Discipline (%) Bandwidth Allocation Order (Bytes)
(Kbps)
___ _____ _____________________ _________ _________ __________ _______ _______
8 1 Priority Queuing 100 0 Rel ative 1 49152
8 2 Weighted Round Robin 41 0 Relative 2 47104
8 3 Weighted Round Robin 19 0 Relative 2 45056