Image not found
file:///var/privatewebfiles/privatefiles/public_images/on%20screen%20menu%20and%20remote%20control_0.JPG
The remote control includes a comprehensive selection of single operation control buttons.
As the same remote control is also used on the companies XT1000 CODEC the four
multifunction colour coded buttons are redundant on the XT5000.
The CODEC remote control includes a single start/finish presentation source button:
Pressing this button for a short period selects the PC presentation source and opens an
H.239 connection
Pressing the button again for a short period closes the H.239 connection
An H.239 connection is initiated and terminated on the remote control via the on-screen
graphical interface. The main camera occupies one channel and the source connected to the
DVI-I input the second channel, normally a PC. At the remote site these two images may
either be viewed on two separate monitors or using POP displayed on a single screen. The
DVI-I input may also be switched to transmit on the main channel if H.239 is not in use.
Alternatively several user controls are available during a call from the graphic user interface;
this is accessed by pressing the OK button on the remote control.
Image not found
file:///var/privatewebfiles/privatefiles/public_images/screen%20user%20interface.JPG
Graphic User Interface
The system takes a significant period to boot up from cold (~70 seconds), on screen graphics
provide useful user feedback that the system is booting up. When not in a call the system
automatically goes into sleep mode after a user-definable period of time, it can also be put
into standby mode via the remote control. An incoming call or a remote control button press
will return the system to active mode.
The Statistics menu displays call status data including connection speed, compression
protocols and packet loss.
The system may also be configured, controlled and monitored via a password protected web
browser from a network connected PC. This facility provided control and monitoring facilities
including an online version of the system remote control. Snapshot images of the local video
at the CODEC are also provided and the user may select the image size and refresh rate of
this image, this web video image of the local camera is however only available when the
system is not in a call. Video snapshots of the far end video are not available.
Image not found
file:///var/privatewebfiles/privatefiles/public_images/web%20configuration%20and%20call%20control%20interfaces_0.JPG
To Next Page
Loading...
