Avaya S8300 - Page 48

Converting an S8300 from ICC to LSP (Communication Manager 2.1 or later)
48 Converting an Avaya S8300 Media Server Between ICC and LSP Modes
3. Reassign endpoints from
the ICC to this primary
controller.
For information on updating
translations, see the
Administrator Guide for Avaya
Communication Manager,
03-300509.
● Update translations — add stations and trunks.
- If the primary controller is a new installation, using
the Avaya Installation Wizard and the Electronic
Pre-Installation Worksheet (EPW) is
recommended
- Alternatively, use SAT commands.
● Place test calls to verify.
● Reassign IA770 users to the messaging system
used by this primary controller. Enter test
messages to verify.
On the DHCP server
4. Update the alternate
controller list on the
DHCP server.
See page 175.
On the gateway’s MGP
5. Telnet to the MGP and
change gateway’s
controller list.
Start on page 487.
● Clear the gateway’s controller list.
● Enter the IP addresses of the primary controller
and up to three alternate controllers.
● Set the LSP transition points.
● If the media gateway is a G350, enter:
copy running-config startup-config
● Reset MGP
On the LSP’s primary controller
6. Verify that the media
gateway has registered
with the primary
controller.
● Open a SAT session and enter list
media-gateway. Verify that the Registered field
(Reg?) is set to y.
● Place a test call.
Task Steps/Comments