Management port
Avaya Virtual Services Platform 4000 Series requires one port to be configured as the management
port. This port separates user traffic from management traffic in highly sensitive environments, such
as brokerages and insurance agencies. By using this dedicated network to manage the switch, and
by configuring access policies (if you enable routing), you can manage the switch in a secure
fashion. You can also use terminal servers to access the console port on the CP module.
If you must access the switch, Avaya recommends that you use the console port. The switch is
always reachable, even if an issue occurs with the in-band network management interface.
Platform power supplies
The Virtual Services Platform 4450GSX series supports both AC and DC power supplies. One
power supply is installed in the system.
You can install a redundant power supply to support additional power requirements or to provide
power redundancy.
The following table describes the Avaya Virtual Services Platform 4000 compatible AC and DC
power supplies and their part numbers (order codes). All the power supplies are EUED RoHS 5/6
compliant.
Note:
The 1000W AC power supply uses the IEC 60320 C16 AC power cord connector.
Use the order codes to order a replacement for the primary PSU or to order a redundant PSU for
your VSP 4000 system.
Table 2: Power supply order codes
VSP 4000 PSU Usage Part number
(order code)
1000W AC POE+
power supply
For use in VSP 4000 4450GSX-PWR+ model. AL1905?21-E6*
300W DC power
supply
For use in the VSP 4850GTS-DC, VSP 4450GSX-DC,
ERS5698TFD, 5650TD, and 5632FD.
DC connector included.
AL1905005-E5
*Note: The seventh character (?) of the switch order number must be replaced with the proper letter to
indicate desired product nationalization. See the following for details:
Table continues…
Management port
November 2016 Installing Avaya Virtual Services Platform 4450GSX-PWR+ Switch 13
Comments on this document? infodev@avaya.com
To Next Page
Loading...
