Label Color and Status Description
Green (blinking) The switch is connected to a secondary power supply, but the
power input is disconnected.
Amber (solid) The power supply in slot 1 or slot 2 was removed after
operating.
Amber (blinking) The power supply in slot 1 or slot 2 is present, but not supplying
power to the switch.
Off No power to secondary power supply. The switch is not
connected to an RPS or secondary power supply. The RPS is
not supplying power, or the DC/DC module is not supplying
power..
Port LED state indicators
This section describes the port LED state indicators by color and fluctuation cues.
Note:
Indicator states are applicable to all models of VSP 4000 switches.
The following list describes the three port LEDs:
• Activity indicates the level of activity on the link.
• Link indicates the presence of an Ethernet link.
• Speed indicates the port speed (for example, 10 Mb/s, 100 Mb/s, 1000 Mb/s).
Table 15: RJ-45 Port LED state indicators
Label Color and Status Description
Speed/PoE+ Green, Blink The port is set to operate at 1000 Mbps with PoE.
Green, Steady The port is set to operate at 1000 Mbps without PoE
+.
Amber, Blink The port is set to operate at 100 Mbps with PoE+.
Amber, Steady The port is set to operate at 100 Mbps without PoE
+.
Amber, Green Pulse The port is experiencing a PoE+ error.
Off When the Link/Activity LED is green and the Speed
LED is off, the port is set to operate at 10 Mbps for
all models.
Link / Activity Green, Steady The link established but no data activity exists.
Green, Blink The link is established and data activity exists (the
blink rate indicates the level of activity).
Green, Slow Blink The port is administratively disabled.
Off Local/remote fault.
Installing the Avaya VSP 4000 4450GSX series
November 2016 Installing Avaya Virtual Services Platform 4450GSX-PWR+ Switch 36
Comments on this document? infodev@avaya.com
To Next Page
Loading...
