Avaya VSP 4450GSX-PWR+ - Installing the Avaya Virtual Services Platform 4000 on a Table or Shelf

2. Rack-mounting hardware that includes:
• Rack-mount brackets
• Screws to attach brackets to the switch
• Screws to attach the switch to the equipment rack
3. Rubber footpads
4. AC power cord with an IEC 60320 C16 connector.
Note:
A power cord is not included for the A variant of the switch.
5. Documentation that includes the following:
a. Locating the latest software and product release notes for Avaya Virtual Services
Platform 4000 Series, NN46251-106
b. Avaya Virtual Services Platform 4000 Series Regulatory Guide, NN46251-105
c. Avaya Virtual Services Platform 4000 Series 4450GSX Quick Install Guide,
NN46251-303
d. The China RoHS paper
Installing the Avaya Virtual Services Platform 4000 on a
table or shelf
You can install a single Avaya VSP 4000 switch on any flat surface. The surface must support the
combined weight of the switch and attached cables (from 15 and 20 pounds [7 to 9 kilograms]).
Note:
A factory-supplied 4450GSX series switch has a USB port but no USB device or cover.
To install an Avaya VSP 4000 on a table or shelf, perform this procedure.
1. Attach the included rubber footpads on the bottom of the switch at the locations indicated.
Installing the Avaya Virtual Services Platform 4000 on a table or shelf
November 2016 Installing Avaya Virtual Services Platform 4450GSX-PWR+ Switch 21
Comments on this document? infodev@avaya.com