05/04 Rev. 1.2-03 USER MANUAL Setup & Operation
AP4.4 – AP5.4
15
Setting the Interface
According to the factory settings, the AP4.4/5.4 is set for data transfer via the
Centronics interface. Print data can also alternately be transferred via the
RS232, USB or Ethernet interface (AP5.4 only).
« Settings for the interfaces are made using the following parameter:
INTERF. PARAM. > EASYPLUGINTERPR > Interface
P To find out how to set parameters, see topic section “Info-Printouts and
Parameters”.
P For part numbers of of power or data cables refer to topic section
„Accessories“.
P For detailed information about using the Ethernet interface, refer to topic
section Advanced Applications
.
Activate/Deactivate Internal Rewinder
¯ Only applies to the model AP5.4 with internal rewinder and deflector!
Deactivate « Call SYSTEM PARAMETER > Periph. Device > None
¯ If you do not insert printing material before activating the rewind function,
an error message will be displayed.
P For details on how to insert printing material, see topic Setup, section
”Inserting Label Stock”.
Activate 1. Call SYSTEM PARAMETER > Periph. Device > Intern Rewinder
¯ Not to be confused with Rewinder - this parameter activates the external
winder (optional extra)!
Upon activation, the rotational direction of the rewinder is set.
2. Press the Cut/Feed button to change the rotation direction.
3. Press Enter to confirm your setting.
The printer is restarted. The main menu now contains the additional menu
REWINDER PARA , which holds the parameter Rewind direction. This can
be used to change the rotational direction again.
During initialisation, the printer attempts to stretch the label material.
Possible Errors Shortly after activating the internal rewinder, the following error message may
be displayed:
Rewinder direct.
Facing outside
Facing outside is the default setting.
Status 5004
Rewinder mat. tear
To Next Page
Loading...
