11/07 Rev. 4.03-01 USER MANUAL Commissioning and Operation
AP3.4
4
Operator Controls
[2] Operator controls of the printer.
Buttons
There are three buttons [2], each having two basic functions.
y FEED Button
The FEED button forces the printer to feed one label when printer is idle (not
printing) or if in PAUSE state.
Holding down the FEED Button then turning on the power switch, the printer
will perform a self test and a configuration report will be printed.
BUTTON Pressed at normal status Pressed during power-on
FEED Feed a label. Perform a self test for configu-
ration report.
PAUSE Stop the printing process
Resume the printing job after
press it again.
Perform the media calibration.
CANCEL Interrupt and delete the prin-
ting job.
Force the printer to continue
working after an error had
been solved.
Reset the settings at
E
2
PROM.
[Tab. 1] Overview buttons.
Power switch
To Next Page
Loading...
