11/07 Rev. 4.03-01 USER MANUAL Commissioning and Operation
AP3.4
8
Performing a Factory Reset
If you would like to reset the printer to its factory defaults after certain com-
mands have been sent or settings changed:
1. Turn off the printer.
2. Turn on the power. Press and hold the CANCEL button.
3. Ribbon indicator blinks, release the button.
Ribbon indicator stops blinking and lights up.
The following parameters automatically reset.
– Label parameters
– Heat(Darkness)
– Speed
– Symbol set (language)
– Others for specific interpreter
¯ All settings stored in non-volatile E
2
PROM cannot be destroyed even by
turning the printer off.
¯ It is necessary to perform label sensitivity calibration after resetting.
¯ The printed label count can not be reset.
To Next Page
Loading...
