Avery Dennison AP4.4 - Operation in Online Mode

05/09 Rev. 5.02-01 USER MANUAL Setup & Operation
AP4.4 – AP5.4
22
• Feed material until the next punch is reached or as long as the button is
held down:
• Setting the label length automatically:
After pressing the two buttons, the printer feeds the label material, until two
punches have passed the label sensor. The measured label length then
will be displayed and saved into parameter PRINT PARAMETERS >
Material length. Furthermore, parameter PRINT PARAMETERS > Material type will
be set to „punched“.
Display of the measured label length:
¯ The label length measured by this function regards the label without the
following punch, what means from label end to label end. If label stock with
very large punches is used, this measurement will not work properly. In this
case, it is adviseable to measure and set the label length manually (label
length + punch length).
Operation in Online Mode
• Switching to offline mode:
• Setting the print contrast: Press the Feed button to increase and the Cut
button to decrease the print contrast.
• Interrupting the print job: The device will finish printing the current label.
• Switching to offline mode while the print job is stopped:
• Continuing the print job:
OFFLINE x JOBS
OFFLINE x JOBS
feeding…
OFFLINE x JOBS
OFFLINE x JOBS
Manual Calibrate
OFFLINE x JOBS
198.5 mm
ONLINE x JOBS
OFFLINE x JOBS
ONLINE x JOBS
Print contrast
xxx%
ONLINE X JOBS
Restcount XXX
ONLINE X JOBS
Stopped XXX
a
a) The message “Stopped xxx” alternates with “Press Feed”.
ONLINE X JOBS
Stopped XXX
OFFLINE x JOBS
ONLINE X JOBS
Stopped XXX
ONLINE X JOBS
Restcount XXX
Feed
Feed
Prog
Online
Prog
Prog
Online
Feed